Yamaha Kodiak 700 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
What's up guys,
I just finished up my clutch kit from EPI tonight, got the "mudder" kit. Fired the machine up and it creeps in high, low, and reverse. Makes it a little difficult to shift into/out of gear even with brake depressed. Fairly certain I did everything correctly, all I can think of is maybe a roller weight out of place or something. There was quite a bit of grease in there when I took it apart, so I didn't clean it out or replace it since i don't have a ton of hours on it. Any advice would be great.
 

·
Registered
Joined
·
83 Posts
yeah i bet a weight is out of place, gotta be careful putting the clutch on so that the weights dont move out of place. keep it sandwiched together. you should be able to tell with the cover off and rev it up and watch the clutch spin in and out, its not closing all the way up. would bet money on it.
 
1 - 2 of 2 Posts
Top