Yamaha Kodiak 700 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
I hooked up a vantage 2000 kit from a Yamaha dealer wired it and it arced pushing bumper back wires got loose now it dont work. Drove wheeler around for a day or 2 and now it wont turn over but lights turn on and cluster is on but wont turn motor over now plz help me any ideas or information wheeler was prewired for the winch
 

·
Super Moderator
Joined
·
1,776 Posts
Start checking voltages. I would start with the fuses. On the 700 they are located in the battery compartment under a plastic cover, your owners manual should show you where they are located at.

Other than that and I am not sure without looking at a service manual but you could of blown the voltage rectifier to where it won't charge the battery and you killed the battery while riding. I am willing to bet that this is the case because the 2000 winch connected directly into the battery and there are no fuses in the circuit.
 
1 - 2 of 2 Posts
Top